Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › CANISTER (for Sedan)

CANISTER (for Sedan) > INSTALLATION



1. INSTALL CHARCOAL CANISTER ASSEMBLY
  1. Install the charcoal canister assembly to the vehicle with the 3 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

  1. Connect the charcoal canister assembly connector.



2. CONNECT FUEL TANK VENT HOSE


    A305538E01
  1. Connect the fuel tank vent hose to the charcoal canister assembly and lock it by pushing in the retainer.
    Text in Illustration 
    *1
    Retainer
    *2
    Fuel Tank Vent Hose Connector
    *3
    O-ring
    V100135
    Push

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the fuel tank vent hose is inserted securely.
    3. After installing the retainer, check that the fuel tank vent hose is securely connected by pulling on it.

    HINT:
    1. Insert the inlet tube until a "click" sound is heard.
    2. The quick connector cannot be locked when the inlet tube is not inserted securely.



3. CONNECT FUEL TANK TO CANISTER TUBE FUEL HOSE
  1. Connect the fuel tank to canister tube fuel hose to the charcoal canister assembly with the hose clip.



4. CONNECT NO. 2 CHARCOAL CANISTER FILTER
  1. Connect the No. 2 charcoal canister filter to the charcoal canister assembly.

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. Check that the No. 2 charcoal canister filter is inserted securely.
    3. Check that the No. 2 charcoal canister filter is securely connected by pulling on it.

    HINT:
    1. Insert the inlet tube until a "click" sound is head.
    2. The quick connector cannot be locked when the inlet tube is not inserted securely.