Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › CANISTER (for Sedan)

CANISTER (for Sedan) > REMOVAL



1. DISCONNECT NO. 2 CHARCOAL CANISTER FILTER


    A302979
  1. Disconnect the No. 2 charcoal canister filter from the charcoal canister assembly as shown in the illustration.
    Text in Illustration 
    V100135
    Push
    V100136
    Pull out

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The quick connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. Do not use any tools.
    4. Do not bend or twist the tubes.
    5. Protect the contact surface by covering it with a plastic bag.
    6. If the connector is stuck, push and pull on the parts to separate them.



2. DISCONNECT FUEL TANK TO CANISTER TUBE FUEL HOSE


    A305541
  1. Loosen the hose clip and disconnect the fuel tank to canister tube fuel hose from the charcoal canister assembly.



3. DISCONNECT FUEL TANK VENT HOSE


    A302978E01
  1. Release the retainer as shown in the illustration and disconnect the fuel tank vent hose from the charcoal canister assembly.
    Text in Illustration 
    *1
    Retainer
    V100135
    Push
    V100136
    Pull

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The quick connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. Do not use any tools.
    4. Do not bend or twist the tubes.
    5. Protect the contact surface by covering it with a plastic bag.
    6. If the connector is stuck, push and pull on the parts to separate them.



4. REMOVE CHARCOAL CANISTER ASSEMBLY


    A305544
  1. Disconnect the charcoal canister assembly connector.



    A305542
  1. Remove the 3 bolts and charcoal canister assembly from the vehicle.