COOLING SYSTEM (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. INSPECT FOR COOLANT LEAK |
![]() |
Fill the radiator assembly with engine coolant, then attach a radiator cap tester.
| *1 | Radiator Cap Tester |
Pump the tester to 137 kPa (1.4 kgf/cm2, 19.9 psi), then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and water pump assembly for leakage. If there are no signs or traces of external engine coolant leakage, check the heater core, cylinder block and head.
| 2. INSPECT RESERVOIR TANK COOLANT LEVEL |
![]() |
The engine coolant level should be between the LOW and FULL lines when the engine is cold.
| *a | FULL Line |
| *b | LOW Line |
| 3. INSPECT COOLANT QUALITY |
Remove the water filler cap sub-assembly.
Check for excessive deposits of rust or scale around the water filler cap sub-assembly and radiator filler hole. The coolant should be free of oil.
If excessively dirty, replace the engine coolant.
Reinstall the water filler cap sub-assembly.