COOLING FAN SYSTEM (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. INSPECT COOLING FAN OPERATION AT LOW TEMPERATURES (Below 83°C (181°F)) |
Turn the ignition switch to ON.
Check that the cooling fan stops.
If not, check the cooling fan relay and engine coolant temperature sensor, and check whether there is disconnection or an open circuit between them.
![]() |
Disconnect the engine coolant temperature sensor connector.
Check that the cooling fan rotates.
If not, check the fuses, cooling fan relay, ECM and cooling fan, and check for a short circuit between the cooing fan relay and engine coolant temperature sensor.
Reconnect the engine coolant temperature sensor connector.
| 2. INSPECT COOLING FAN OPERATION AT HIGH TEMPERATURES (Above 96°C (205°F)) |
Start the engine and turn the air conditioning switch off, and raise the engine coolant temperature to above 96°C (205°F).
Check that the cooling fan rotates.
If not, replace the engine coolant temperature sensor.