RADIATOR (for Hatchback) > REMOVAL |
| 1. DRAIN COOLANT |
![]() |
Loosen the radiator drain cock plug.
| *1 | Water Filler Cap Sub-assembly |
| *2 | Radiator Drain Cock Plug |
Remove the water filler cap sub-assembly, then drain the coolant.
| 2. REMOVE HEADLIGHT ASSEMBLY |
| 3. SEPARATE HOOD LOCK CONTROL CABLE ASSEMBLY |
![]() |
Disengage the 2 clamps and separate the hood lock cable assembly.
Separate the hood lock control cable assembly from the hood lock.
| 4. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY |
![]() |
Disconnect the hood lock courtesy switch connector and disengage the wire harness clamp.
![]() |
Separate the horn assembly connector.
Remove the 4 bolts and the upper radiator support sub-assembly.
| 5. DISCONNECT RADIATOR RESERVOIR TANK HOSE |
![]() |
Disconnect the radiator reservoir tank hose from the water filler.
| 6. REMOVE NO. 3 RADIATOR HOSE |
![]() |
Loosen the 2 clips and remove No. 3 radiator hose.
| 7. DISCONNECT NO. 2 RADIATOR HOSE |
![]() |
Loosen the clip and disconnect No. 2 radiator hose.
| 8. REMOVE INLET OIL COOLER HOSE (for Automatic Transaxle) |
![]() |
| 9. REMOVE OUTLET OIL COOLER HOSE (for Automatic Transaxle) |
![]() |
| 10. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Disengage the clamp and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose.
Loosen the 2 hose clamps and disconnect the fuel vapor feed hose assembly from the No. 1 air cleaner hose and vacuum switching valve assembly.
![]() |
Disconnect the No. 2 fuel vapor feed hose from the intake manifold.
![]() |
Disengage the 2 clamps and disconnect the wire harness from the air cleaner cap sub-assembly and vacuum switching valve assembly.
Disconnect the mass air flow meter connector.
Disconnect the vacuum switching valve connector.
![]() |
Loosen the hose clamp and disconnect the No. 1 air cleaner hose from the throttle with motor body assembly.
Disengage the 2 clamps and remove the air cleaner cap sub-assembly with No. 1 air cleaner hose.
![]() |
Remove the air cleaner element.
![]() |
Disengage the clamp and disconnect the wire harness from the air cleaner case.
Remove the 2 bolts and the air cleaner case from the air cleaner bracket.
| 11. REMOVE RADIATOR ASSEMBLY |
![]() |
Separate the cooling fan motor connector and wire harness clamp.
![]() |
Disengage the 2 claws and remove the radiator assembly from the vehicle.
| 12. REMOVE NO. 2 RADIATOR HOSE |
![]() |
Loosen the clip and remove the No. 2 radiator hose.
| 13. REMOVE FAN SHROUD |
![]() |
Disengage the 2 claws and remove the fan shroud.
| 14. REMOVE RADIATOR SUPPORT CUSHION |
![]() |
Remove the 2 radiator support cushions from the radiator assembly.
| 15. REMOVE GROMMET |
![]() |
Remove the 2 grommets from the radiator assembly.
| 16. REMOVE RADIATOR DRAIN COCK |
![]() |
Remove the radiator drain cock from the radiator assembly.