ENGINE UNIT (for Sedan) > INSTALLATION |
| 1. INSTALL EXHAUST MANIFOLD |
![]() |
Install the exhaust manifold with the 3 bolts and 2 nuts, in the order shown in the illustration, through a new gasket.
| 2. INSTALL MANIFOLD SUPPORT BRACKET |
Install the manifold bracket with the 3 bolts.
| 3. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
Install the exhaust manifold insulator with the 4 bolts.
| 4. INSTALL WIRE HARNESS CLAMP BRACKET |
![]() |
Install the 2 wire harness clamp brackets with the 2 bolts.
| 5. INSTALL ENGINE WIRE |
Connect all sensor connectors and wire harness clamps to the engine assembly and install the engine wire harness.
| 6. INSTALL BOOSTER VACUUM TUBE |
Install the booster vacuum tube with the 2 bolts.
| 7. INSTALL NO. 1 WATER BY-PASS PIPE |
Install the No. 1 water bypass pipe through a new gasket with the 2 bolts and 2 nuts.
| 8. INSTALL INTAKE MANIFOLD |
Install a new gasket onto the intake manifold.
![]() |
Provisionally tighten the intake manifold nuts and bolts in the order shown in the illustration, and then tighten them to the specified torque.
Connect the water by-pass hose to the No. 1 water by-pass pipe.
Connect the water bypass hose to the cylinder head.
Connect the union to connector tube hose to the booster vacuum tube.
| 9. INSTALL ENGINE OIL LEVEL DIPSTICK |
| 10. INSTALL GENERATOR ASSEMBLY |
![]() |
Provisionally install the generator with fixing bolt B.
![]() |
Provisionally install the fan belt adjusting slider with fan belt adjusting slider fixing bolts A and B, then move the generator toward the cylinder block and tighten bolt B.
![]() |
Install the connector and the wire harness clamp.
Install terminal B with the nut.
Install the terminal cap.
| 11. INSTALL NO. 1 IGNITION COIL |
![]() |
Install the 4 ignition coils with the 4 bolts.
![]() |
| *1 | Body |
| *2 | Cap |
![]() |
Connect the 4 ignition coil connectors.
| 12. INSTALL WATER FILLER SUB-ASSEMBLY |
Connect the No. 1 radiator hose to the cylinder head.
Install the water filler sub-assembly with 2 nuts.
| 13. INSTALL FUEL TUBE SUB-ASSEMBLY |
![]() |
Insert the fuel tube connector into the fuel delivery pipe until a click sound can be heard.
![]() |
Install the fuel pipe clamp.
| 14. INSTALL VENTILATION HOSE |
Install the ventilation hose.