ENGINE UNIT (for Hatchback) > INSTALLATION |
| 1. INSTALL WIRE HARNESS CLAMP BRACKET |
Install the 2 wire harness clamp brackets with the 2 bolts.
| 2. INSTALL BOOSTER VACUUM TUBE |
Install the booster vacuum tube with the 2 bolts.
| 3. INSTALL NO. 1 WATER BY-PASS PIPE |
Install the No. 1 water by-pass pipe through a new gasket with the 2 bolts and 2 nuts.
| 4. INSTALL GENERATOR ASSEMBLY |
![]() |
Temporarily install the generator assembly with the fixing bolt.
![]() |
Install the piping clamp with the bolt A and screw B.
![]() |
Temporarily install the fan belt adjusting slider with fan belt adjusting slider fixing bolt A and nut B.
Move generator assembly toward the cylinder block and tighten nut B.
Connect the connector and engage the clamp.
Install the wire harness to terminal B with the nut.
Install the terminal cap.