ENGINE UNIT (for Sedan) > REMOVAL |
| 1. REMOVE VENTILATION HOSE |
Remove the ventilation hose.
| 2. REMOVE FUEL TUBE SUB-ASSEMBLY |
![]() |
Remove the fuel pipe clamp.
![]() |
Pinch the retainer of the fuel tube connector, then pull the fuel tube connector to disconnect the fuel tube out of the fuel delivery pipe sub-assembly.
| 3. REMOVE WATER FILLER SUB-ASSEMBLY |
![]() |
Disconnect the No. 1 radiator hose from the cylinder head.
Remove the 2 nuts and remove the water filler sub-assembly.
| 4. REMOVE NO. 1 IGNITION COIL |
![]() |
Disconnect the 4 ignition coil connectors.
![]() |
Remove the 4 bolts and 4 ignition coils.
| 5. REMOVE GENERATOR ASSEMBLY |
![]() |
Remove the terminal cap.
Separate the connector and the harness clamp.
Remove the nut and remove terminal B.
![]() |
Remove fan belt adjusting slider fixing bolts A and B and remove the fan belt adjusting slider.
![]() |
Remove fixing bolt B and remove the generator.
| 6. REMOVE ENGINE OIL LEVEL DIPSTICK |
| 7. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the union to connector tube hose from the booster vacuum tube.
![]() |
Disconnect the water bypass hose from the cylinder head.
![]() |
Disconnect the water bypass hose from the No. 1 water bypass pipe.
![]() |
Remove the 3 bolts and 2 nuts and remove the intake manifold.
Remove the gasket from the intake manifold.
| 8. REMOVE NO. 1 WATER BY-PASS PIPE |
![]() |
Remove the 2 bolts and 2 nuts and remove the No. 1 water bypass pipe.
| 9. REMOVE BOOSTER VACUUM TUBE |
![]() |
Remove the 2 bolts and remove the booster vacuum tube.
| 10. REMOVE ENGINE WIRE |
Disconnect all sensor connectors and wire harness clamps from the engine assembly and remove the engine wire harness.
| 11. REMOVE WIRE HARNESS CLAMP BRACKET |
![]() |
Remove the 2 bolts and remove the 2 wire harness clamp brackets.
| 12. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 4 bolts and remove the exhaust manifold heat insulator.
| 13. REMOVE MANIFOLD SUPPORT BRACKET |
![]() |
Remove the 3 bolts and remove the manifold support bracket.
| 14. REMOVE EXHAUST MANIFOLD |
![]() |
Remove the 3 bolts and 2 nuts and remove the exhaust manifold.