Home › Engine / Hybrid System › 1NZ-FE ENGINE MECHANICAL › ENGINE UNIT (for Hatchback)

ENGINE UNIT (for Hatchback) > REMOVAL



1. REMOVE GENERATOR ASSEMBLY


A249989E01
  1. Remove the terminal cap.

  1. Disconnect the connector and the harness clamp.

  1. Remove the nut and disconnect the wire harness from terminal B.
    Text in Illustration 
    *1
    Terminal B



    A244005E01
  1. Remove the belt adjusting slider fixing bolt A, nut B and the belt adjusting slider.



    A247897E01
  1. Remove the bolt A, screw B and the piping clamp.



    A244006
  1. Remove the fixing bolt and the generator assembly.



2. REMOVE NO. 1 WATER BY-PASS PIPE


    A166742
  1. Remove the 2 bolts, 2 nuts and the No. 1 water by-pass pipe.



3. REMOVE BOOSTER VACUUM TUBE


    A117316
  1. Remove the 2 bolts and the booster vacuum tube.



4. REMOVE WIRE HARNESS CLAMP BRACKET


    A107284
  1. Remove the 2 bolts and the 2 wire harness clamp brackets.