OIL AND OIL FILTER (for Sedan) > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap sub-assembly.
Remove the oil pan drain plug and the gasket from the No. 2 oil pan sub-assembly, and drain the engine oil into a container.
Clean and install the oil pan drain plug with a new gasket to the No. 2 oil pan sub-assembly.
| 2. REMOVE OIL FILTER SUB-ASSEMBLY |
![]() |
Using SST, remove the oil filter sub-assembly from the oil filter union.
| 3. INSTALL OIL FILTER SUB-ASSEMBLY |
Clean the oil filter sub-assembly installation surface.
Apply clean engine oil to the gasket of a new oil filter sub-assembly.
Lightly screw the oil filter sub-assembly into place by hand. Tighten oil filter sub-assembly until the gasket contacts the seat.
![]() |
Using SST, tighten the oil filter sub-assembly an additional 3/4 turn.
| 4. ADD ENGINE OIL |
Add fresh engine oil.
| Oil Grade | Oil Viscosity (SAE) |
| API grade SL "energy- conserving", SM "energy- conserving", SN "resource-conserving", or ILSAC multigrade engine oil |
|
| API grade SL, SM or SN multigrade engine oil |
|
| Item | Capacity |
| Drain and refill with oil filter change | 3.7 liters (3.9 US qts, 3.3 Imp. qts) |
| Drain and refill without oil filter change | 3.4 liters (3.6 US qts, 3.0 Imp. qts) |
| Dry fill | 4.1 liters (4.3 US qts, 3.6 Imp. qts) |
Install the oil filler cap sub-assembly.
| 5. INSPECT FOR OIL LEAK |
| 6. INSPECT FOR ENGINE OIL LEVEL |
Warm up the engine, then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the low and full marks on the engine oil level dipstick.
If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.