Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE (for Hatchback)

FRONT BRAKE FLEXIBLE HOSE (for Hatchback) > INSTALLATION



1. INSTALL FRONT BRAKE FLEXIBLE HOSE
  1. Install the flexible hose with a new union bolt and a new gasket.

    Torque:
    30 N*m{ 310 kgf*cm , 22 ft.*lbf }

    HINT:
    Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

  1. Install the flexible hose and speed sensor with the bolt.

    Torque:
    29 N*m{ 300 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Install the flexible hose and speed sensor without twisting them.

  1. Install the flexible hose with a new clip.

  1. Using a union nut wrench 10 mm, install the brake tube to the flexible hose while holding the flexible hose with a wrench.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



2. BLEED BRAKE LINE
(Click here)


3. BLEED CLUTCH LINE (for Manual Transaxle)
(Click here)


4. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1050 kgf*cm , 76 ft.*lbf }