Home › Brake › BRAKE (REAR) › REAR BRAKE (for Hatchback Disc Type)

REAR BRAKE (for Hatchback Disc Type) > REMOVAL


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure listed is for the LH side.



1. REMOVE REAR WHEEL


2. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



3. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


4. LOOSEN PARKING BRAKE CABLE


C234723E03
  1. Loosen the equalizer and lock nut.
    Text in Illustration 
    *1
    Parking Brake Equalizer
    *2
    Lock Nut

    NOTICE:
    Do not reuse the loosened nut.



5. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    C235479
  1. Separate the No. 3 parking brake cable assembly from the rear disc brake cylinder operation lever.



    C235480E01
  1. Insert an offset wrench 14 mm at the base of the parking brake cable as shown in the illustration to disengage the clip. Pull out the parking brake cable from the rear disc brake cylinder assembly.
    Text in Illustration 
    *1
    No. 3 Parking Brake Cable Assembly
    *2
    Clip
    *3
    Offset Wrench 14 mm



6. DISCONNECT REAR BRAKE FLEXIBLE HOSE


    C235486
  1. Remove the union bolt and gasket and separate the rear brake flexible hose from the disc brake cylinder assembly.



7. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY


    C235487
  1. Hold the rear disc brake pad guide pin and remove the 2 bolts and the rear disc brake cylinder assembly.



8. REMOVE REAR DISC BRAKE PAD KIT (PAD ONLY)


    C130339
  1. Remove the 2 disc brake pads from the rear disc brake cylinder mounting.



9. REMOVE REAR DISC BRAKE ANTI SQUEAL SHIM KIT
  1. Remove the 2 No. 1 rear disc brake anti squeal shims and the 2 No. 2 rear disc brake anti squeal shims from the brake pads.



10. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE


    C235488E01
  1. Remove the No. 1 rear disc brake pad support plate and the No. 2 rear disc brake pad support plate from the rear disc brake cylinder mounting.
    Text in Illustration 
    *1
    No. 1 Rear Disc Brake Pad Support Plate
    *2
    No. 2 Rear Disc Brake Pad Support Plate

    NOTICE:
    Each pad support plate has a different shape. Be sure to put an identification mark on each pad support plate so that they can be installed to their original position.



11. REMOVE REAR DISC BRAKE PAD GUIDE PIN


    C235489
  1. Remove the 2 rear disc brake pad guide pins from the disc brake cylinder mounting.



12. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH


    C235591E01
  1. Using a screwdriver with its tip wrapped in protective tape, remove the slide bush from the slide pin.
    Text in Illustration 
    *1
    Slide Bush
    *2
    Protective Tape



13. REMOVE REAR DISC BRAKE BUSHING DUST BOOT


    C235490
  1. Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.



14. REMOVE REAR DISC BRAKE CYLINDER MOUNTING


    C235491
  1. Remove the 2 bolts and the rear disc brake cylinder mounting from the axle beam.



15. REMOVE REAR DISC


    C236431E01
  1. Place matchmarks on the rear disc and axle hub, and remove the rear disc.
    Text in Illustration 
    *a
    Matchmark