Home › Brake › BRAKE (REAR) › REAR BRAKE (for Hatchback Disc Type)

REAR BRAKE (for Hatchback Disc Type) > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The following procedure listed is for the LH side.



1. REMOVE REAR DISC BRAKE PISTON


    C219091E01
  1. Using SST, remove the rear disc brake piston by turning it counterclockwise.

    SST
    09719-12010   (09719-01030)

    NOTICE:
    1. Do not damage the rear disc brake piston.
    2. Do not allow any brake fluid to spatter.

    HINT:
    For the RH side, turn the rear disc brake piston clockwise.



2. REMOVE CYLINDER BOOT
  1. Remove the cylinder boot from the rear disc brake piston.



3. REMOVE PISTON SEAL


    C116888E04
  1. Using a screwdriver with its tip wrapped in protective tape, remove the piston seal from the rear disc brake cylinder assembly.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not damage the inner surface or piston seal groove of the rear disc brake cylinder assembly.



4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


5. REMOVE REAR DISC BRAKE BLEEDER PLUG