REAR BRAKE (for Hatchback Disc Type) > REASSEMBLY |
| 1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG |
| 2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP |
| 3. INSTALL PISTON SEAL |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal as shown in the illustration.
| *1 | Lithium Soap Base Glycol Grease |
Install the piston seal to the rear disc brake cylinder.
| 4. INSTALL CYLINDER BOOT |
![]() |
Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot as shown in the illustration.
| *1 | Cylinder Boot |
| *2 | Disc Brake Piston |
| *3 | Lithium Soap Base Glycol Grease |
Apply a light layer of lithium soap base glycol grease to the entire circumference of the rear disc brake piston as shown in the illustration.
Install the cylinder boot to the rear disc brake piston.
| 5. INSTALL REAR DISC BRAKE PISTON |
![]() |
Install the seal portion of the cylinder boot into the groove portion of the rear disc brake cylinder.
| *a | Seal Portion |
| *b | Groove Portion |
![]() |
Using SST, screw the piston to the end by turning it clockwise as far as possible.
![]() |
Using SST, slowly turn the piston counterclockwise until the piston groove is positioned as shown in the illustration.
![]() |
Make sure that the cylinder boot is securely installed into the groove of the disc brake cylinder and disc brake piston.
| *1 | Cylinder Boot |