FUEL INJECTOR (for Sedan) > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance between the terminals.
Check the operation.
![]() |
Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).
Install the O-ring onto the fuel injector assembly.
![]() |
Connect SST (adaptor and hose) to the injector assembly, and hold the injector assembly and union with SST (clamp).
Set the injector assembly in a graduated cylinder.
Operate the fuel pump .
![]() |
Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
![]() |
Check the leakage.
In the condition above, disconnect the test probes of SST (wire) from the battery and check the injector for fuel leakage.