UPPER INSTRUMENT PANEL (for Sedan) > REMOVAL |
| 1. BOLTS, SCREWS AND NUTS TABLE |

| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
| 3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
| 4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() |
Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.
| 5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH |
![]() |
Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end RH.
| 6. REMOVE INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Disengage the 7 claws and 5 clips and remove the instrument cluster finish panel.
| 7. REMOVE COMBINATION METER ASSEMBLY |
![]() |
Disconnect the 2 connectors.
Remove the 2 screws and pull the combination meter rearward to remove it.
| 8. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
Separate the front door opening trim weatherstrip.
| 9. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
Separate the front door opening trim weatherstrip.
| 10. REMOVE FRONT PILLAR GARNISH RH |
![]() |
Disengage the 2 clips and the 2 claws and remove the front pillar garnish.
![]() |
Disconnect the antenna connector.
Using a clip remover, remove the 3 clamps.
| 11. REMOVE FRONT PILLAR GARNISH LH |
![]() |
Disengage the 2 clips and the 2 claws and remove the front pillar garnish.
![]() |
Using a clip remover, remove the 4 clamps.
| 12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY |
![]() |
Disengage the claw and separate the 2 glove compartment door stoppers from the glove compartment door.
Slightly flex the upper part of the glove compartment door to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.
![]() |
Pull the glove compartment door assembly out horizontally to disengage the hinge portion and remove the glove compartment door.
| 13. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY |
![]() |
Slide the slider and disconnect the passenger airbag connector.
Disconnect the clamp.
Remove the 2 <C> bolts and 2 <B> screws.

Disengage the 7 clips by lifting the rear side of the instrument panel up.

While lifting the instrument panel, slide it toward the rear of the vehicle. Disengage the 5 claws from the front side of the instrument panel and remove the instrument panel.