Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG (for Sedan)

IGNITION COIL AND SPARK PLUG (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE CYLINDER HEAD COVER NO. 2


A116235
  1. Remove the 4 nuts and cylinder head cover No. 2.



3. REMOVE IGNITION COIL NO. 1


A115484
  1. Disconnect the 4 ignition coil connectors.



    A115485
  1. Remove the 4 bolts and 4 ignition coils.



4. REMOVE SPARK PLUG
  1. Using a 14 mm spark plug wrench, remove the 4 spark plugs.