LUGGAGE COMPARTMENT DOOR (for Sedan) > ADJUSTMENT |

| 1. INSPECT LUGGAGE COMPARTMENT DOOR |
Check that the clearance measurements are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 2.6 to 5.6 mm (0.102 to 0.220 in.) | C | 6.45 mm (0.254 in.) |
| B | -0.6 to 1.4 mm (-0.023 to 0.055 in.) | - | - |
| 2. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Remove the 2 clips.
Disengage the 8 claws and remove the rear floor finish plate.
| 3. ADJUST LUGGAGE COMPARTMENT DOOR |
![]() |
Adjust the door position.
Horizontally and vertically adjust the door by loosening the door side hinge bolts.
![]() |
Adjust the striker position.
Adjust the striker position by slightly loosening the striker mounting bolts and hitting the striker with a plastic hammer.
Tighten the striker mounting bolts after the adjustment.
| 4. INSTALL REAR FLOOR FINISH PLATE |
![]() |
Engage the 8 claws and install the rear floor finish plate.
Install the 2 clips.