GENERATOR (for Hatchback) > DISASSEMBLY |
| 1. REMOVE GENERATOR PULLEY |
![]() |
Clamp the generator housing stay in a vise tightly.
Hold SST1-A with a torque wrench, and tighten SST1-B clockwise to the specified torque.
| *a | Hold |
| *b | Turn |
![]() |
Insert SST2, and engage SST2 to the generator pulley nut.
![]() |
To loosen the generator pulley nut, turn SST1-A in the direction shown in the illustration.
| *a | Hold |
| *b | Turn |
Remove SST2 from the generator assembly.
![]() |
Hold SST1-A, turn SST1-B, and remove SST1-A and SST1-B in the direction shown in the illustration.
| *a | Hold |
| *b | Turn |
Remove the generator pulley nut and generator pulley.
Remove the generator assembly from a vise.
| 2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Remove the nut and generator terminal insulator.
![]() |
Remove the nut A, screw and rectifier plate.
| *1 | Rectifier Plate |
Remove the 2 nuts B, and the generator rear end cover.
![]() |
Remove the generator brush cover.
Remove the 3 screws and the generator brush holder assembly.
Remove the generator plate seal.
| *1 | Generator Brush Cover |
| *2 | Generator Brush Holder Assembly |
| *3 | Generator Plate Seal |
| 3. REMOVE GENERATOR REGULATOR ASSEMBLY |
![]() |
Remove the 2 screws and generator regulator assembly.
| 4. REMOVE GENERATOR HOLDER WITH RECTIFIER |
![]() |
Remove the 3 screws and generator holder with rectifier.
| 5. REMOVE GENERATOR ROTOR ASSEMBLY |
![]() |
Remove the 3 terminal insulators from the generator rectifier end frame.
Remove the 3 nuts A, nut B and cord clip.
| *1 | Terminal Insulator |
| *2 | Cord Clip |
![]() |
Using SST, remove the generator rectifier end frame.
| *1 | Wooden Block |
| *a | Hold |
| *b | Turn |
![]() |
Remove the generator washer from the generator rotor assembly.
![]() |
Using a plastic hammer, remove the generator rotor assembly from the generator drive end frame assembly.
| *1 | Wooden Block |
| *2 | Plastic Hammer |