GENERATOR (for Hatchback) > REASSEMBLY |
| 1. INSTALL GENERATOR ROTOR ASSEMBLY |
![]() |
Place the generator rotor assembly on the generator drive end frame assembly.
Using a plastic hammer, install the generator rotor assembly to the generator drive end frame assembly.
![]() |
Install a new generator washer on the generator rotor assembly.
![]() |
Using a 30 mm/12 pt socket wrench and press, slowly press in the generator rectifier end frame.
| *1 | 30 mm/ 12 pt Socket Wrench |
![]() |
Install the 3 nuts A.
Install the 3 terminal insulators onto the generator rectifier end frame.
Install the cord clip with the nut B.
| *1 | Terminal Insulator |
| *2 | Cord Clip |
| 2. INSTALL GENERATOR HOLDER WITH RECTIFIER |
![]() |
Install the generator holder with rectifier with the 3 screws.
| 3. INSTALL GENERATOR REGULATOR ASSEMBLY |
![]() |
Install the generator regulator assembly with the 2 screws.
| 4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Install the generator plate seal.
Install the generator brush holder assembly with the 3 screws.
Install the generator brush cover onto the generator brush holder assembly.
| *1 | Generator Brush Cover |
| *2 | Generator Brush Holder Assembly |
| *3 | Generator Plate Seal |
![]() |
Install the generator rear end cover with the 2 nuts B.
Install the rectifier plate with the nut A and screw.
| *1 | Rectifier Plate |
| 5. INSTALL GENERATOR TERMINAL INSULATOR |
![]() |
Install the generator terminal insulator with the nut.
| 6. INSTALL GENERATOR PULLEY |
![]() |
Clamp the generator housing stay in a vise tightly.
Install the generator pulley onto the generator rotor shaft by tightening the generator pulley nut by hand.
Hold SST1-A with a torque wrench, and tighten SST1-B clockwise to the specified torque.
| *a | Hold |
| *b | Turn |
![]() |
Insert SST2, and engage SST2 to the pulley nut.
![]() |
Tighten the generator pulley nut by turning SST1-A in the direction shown in the illustration.
| *a | Hold |
| *b | Turn |
Remove SST 2 from the generator assembly.
![]() |
Hold SST1-A, turn SST1-B, and remove SST1-A and SST1-B from the generator assembly.
| *a | Hold |
| *b | Turn |
Turn the generator pulley, and check that the generator pulley moves smoothly.
Remove the generator assembly from a vise.