Home › Drivetrain ยท CLUTCH › CLUTCH RELEASE CYLINDER (for Hatchback)

CLUTCH RELEASE CYLINDER (for Hatchback) > REASSEMBLY



1. INSTALL RELEASE CYLINDER BLEEDER PLUG
  1. Install the release cylinder bleeder plug to the release cylinder body.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



2. INSTALL CLUTCH RELEASE CYLINDER KIT
  1. Install the release cylinder bleeder plug cap to the release cylinder bleeder plug.



    C128485
  1. Apply lithium soap base glycol grease to a new release cylinder piston.
    Text in Illustration 
    V100135
    Lithium soap base glycol grease

  1. Install a new compression spring and the release cylinder piston to the release cylinder body.

    NOTICE:
    Do not damage the inside of the release cylinder body.

    HINT:
    Install the smaller end of the compression spring to the release cylinder piston.

  1. Install a new clutch release cylinder boot to the No. 1 clutch release cylinder push rod.

  1. Install the clutch release cylinder boot and the No. 1 clutch release cylinder push rod to the release cylinder body.