NAME PLATE (for Sedan) > INSTALLATION |
| 1. INSTALL SYMBOL EMBLEM |
![]() |
Clean the attachment surface.
| *a | Peeling Paper |
| *b | Location Pin |
Using an infrared light, heat the double-sided tape remaining on the luggage compartment door panel.
Using a piece of cloth, rub the remaining double-sided tape off the luggage compartment door panel while it is hot from the infrared light.
Using a non-residue solvent, clean the attachment surface.
Align the 2 location pins and install a new symbol emblem.
| 2. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE |
![]() |
Clean the attachment surface.
| *a | Peeling Paper |
| *b | Outside Line of Luggage Compartment Door Panel |
Using an infrared light, heat the double-sided tape remaining on the luggage compartment door panel.
Using a piece of cloth, rub the remaining double-sided tape off the luggage compartment door panel while it is hot from the infrared light.
Using a non-residue solvent, clean the attachment surface.
Install a new No. 2 luggage compartment door name plate as shown in the illustration.
| Mark | Measurement (along surface) |
| a | 39.4 mm (1.551 in.) |
| b | 44.7 mm (1.760 in.) |
| c | 162.4 mm (6.394 in.) |
| d | 17.8 mm (0.701 in.) |
| 3. INSTALL FRONT BUMPER EMBLEM |
Engage the 4 claws and install the front bumper emblem.
| 4. INSTALL FRONT BUMPER COVER |