Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › NAME PLATE (for Sedan)

NAME PLATE (for Sedan) > INSTALLATION



1. INSTALL SYMBOL EMBLEM


    B126358E01
  1. Clean the attachment surface.
    Text in Illustration 
    *a
    Peeling Paper
    *b
    Location Pin

    1. Using an infrared light, heat the double-sided tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a piece of cloth, rub the remaining double-sided tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the symbol emblem while any double-sided tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Align the 2 location pins and install a new symbol emblem.

    NOTICE:
    Install the symbol emblem in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the luggage compartment door panel and the symbol emblem to 20 to 30°C (68 to 86°F) and install the symbol emblem.



2. INSTALL NO. 2 LUGGAGE COMPARTMENT DOOR NAME PLATE


    B134867E03
  1. Clean the attachment surface.
    Text in Illustration 
    *a
    Peeling Paper
    *b
    Outside Line of Luggage Compartment Door Panel

    1. Using an infrared light, heat the double-sided tape remaining on the luggage compartment door panel.

      HINT:
      Heat at 40 to 60°C (104 to 140°F) for 1 to 2 minutes.

    2. Using a piece of cloth, rub the remaining double-sided tape off the luggage compartment door panel while it is hot from the infrared light.

      NOTICE:
      Installing the No. 2 luggage compartment door name plate while any double-sided tape remains on the luggage compartment door panel may cause adhesion failure. Therefore, completely remove the double-sided tape.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Install a new No. 2 luggage compartment door name plate as shown in the illustration.

    Installation Position:
    Mark
    Measurement (along surface)
    a
    39.4 mm (1.551 in.)
    b
    44.7 mm (1.760 in.)
    c
    162.4 mm (6.394 in.)
    d
    17.8 mm (0.701 in.)

    NOTICE:
    Install the No. 2 luggage compartment door name plate in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the luggage compartment door panel and the No. 2 luggage compartment door name plate to 20 to 30°C (68 to 86°F) and install the No. 2 luggage compartment door name plate.



3. INSTALL FRONT BUMPER EMBLEM
  1. Engage the 4 claws and install the front bumper emblem.



4. INSTALL FRONT BUMPER COVER
(Click here)