Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING (for Sedan)

ROOF DRIP SIDE FINISH MOULDING (for Sedan) > INSTALLATION


HINT:
The procedure described below is for LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP


B134858E01

NOTICE:
Follow these procedures only when replacing the clips.

  1. Remove the tape that remains on the moulding surface of the vehicle body, then clean the surface with a non-residue solvent.

  1. Using an infrared light, heat the clip installation surface of the vehicle body.

    Heating Temperature:
    Area
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)

    NOTICE:
    Do not excessively heat the vehicle body.

  1. Install new clips in the positions shown in the illustration. Press in the clips by hand.

    Specification:
    Area
    Measurement
    a
    3.5 mm (0.138 in.)
    b
    1.1 mm (0.043 in.)
    c
    1.8 mm (0.071 in.)
    d
    2.3 mm (0.091 in.)

    NOTICE:
    After pressing in the clips, wait 30 minutes or more before installing the roof drip side finish moulding.

    HINT:
    1. Minimum hardening time: 30 minutes
    2. Time needed for complete hardening: 24 hours



2. INSTALL ROOF DRIP SIDE FINISH MOULDING


    B134859
  1. Engage the 2 clips and install the roof drip side finish moulding.



    B138358E01
  1. Remove the protective tape.