Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING (for Sedan)

ROOF DRIP SIDE FINISH MOULDING (for Sedan) > REMOVAL


HINT:
The procedure described below is for LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B138358E01
  1. Apply protective tape, as shown in the illustration.



    B134857
  1. Disengage the 2 clips and remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. Replace the clips with supply clips if damaged.