REAR BUMPER (for Sedan) > INSTALLATION |
| 1. INSTALL REAR BUMPER ARM SUB-ASSEMBLY LH |
![]() |
Install the rear bumper arm with the 3 bolts.
| 2. INSTALL REAR BUMPER ARM SUB-ASSEMBLY RH |
| 3. INSTALL REAR BUMPER REINFORCEMENT |
![]() |
Install the rear bumper reinforcement with the 4 nuts.
| 4. INSTALL REAR BUMPER SIDE SUPPORT LH |
![]() |
Engage the 2 claws and install the rear bumper side support.
Tighten the screw.
| 5. INSTALL REAR BUMPER SIDE SUPPORT RH |
| 6. INSTALL REAR BUMPER SIDE RETAINER LH |
![]() |
Engage the 3 claws and install the rear bumper side retainer.
Tighten the screw.
Install the clip.
| 7. INSTALL REAR BUMPER SIDE RETAINER RH |
| 8. INSTALL REAR BUMPER COVER |
![]() |
Engage the 18 claws and install the rear bumper cover.
![]() |
Tighten the 2 bolts and the 2 screws.
Install the 2 clips.
![]() |
Remove the protective tape.
| 9. INSTALL REAR BUMPER SIDE SEAL LH |
![]() |
Install the rear bumper side seal with the 3 clips.
| 10. INSTALL REAR BUMPER SIDE SEAL RH |