Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER (for Sedan)

REAR BUMPER (for Sedan) > REMOVAL



1. REMOVE REAR BUMPER SIDE SEAL LH


    B134832
  1. Using a clip remover, remove the 3 clips and the rear bumper side seal.



2. REMOVE REAR BUMPER SIDE SEAL RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR BUMPER COVER


    B134833E01
  1. Apply protective tape as shown in the illustration.



    B134834
  1. Using a clip remover, remove the 2 clips.

  1. Remove the 2 bolts and the 2 screws.



    B138619E01
  1. Insert a screwdriver into portion A shown in the illustration, then lift the rear bumper cover up using it and disengage the 2 claws.

  1. Disengage the 16 claws and remove the rear bumper cover.



4. REMOVE REAR BUMPER SIDE RETAINER LH


    B134837
  1. Using a clip remover, remove the clip.

  1. Remove the screw.

  1. Disengage the 3 claws and remove the rear bumper side retainer.



5. REMOVE REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure as for the LH side.



6. REMOVE REAR BUMPER SIDE SUPPORT LH


    B134838
  1. Remove the screw.

  1. Disengage the 2 claws and remove the rear bumper side support.



7. REMOVE REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.



8. REMOVE REAR BUMPER REINFORCEMENT


    B134840
  1. Remove the 4 nuts and rear bumper reinforcement.



9. REMOVE REAR BUMPER ARM SUB-ASSEMBLY LH


    B134842
  1. Remove the 3 bolts and the rear bumper arm.



10. REMOVE REAR BUMPER ARM SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.