Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR WINDOW FRAME MOULDING (for Hatchback Rear Side)

FRONT DOOR WINDOW FRAME MOULDING (for Hatchback Rear Side) > INSTALLATION



1. INSTALL FRONT DOOR WINDOW FRAME REAR MOULDING
  1. Clean the attachment surface.

    1. Using an infrared light, heat the adhesive remaining on the body.

      CAUTION:
      Do not burn yourself with the heated body or infrared light.

    2. Using a piece of cloth, rub the remaining adhesive off the body.

    3. Using a non-residue solvent, clean the attachment surface.

  1. Remove the release paper from the front door window frame rear moulding.

  1. Engage the 2 clips and install a new front door window frame rear moulding.

    NOTICE:
    Thoroughly press the front door window frame rear moulding to ensure that it adheres.