Home › Vehicle Interior › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY (for Hatchback LH Side)

REAR SEAT INNER BELT ASSEMBLY (for Hatchback LH Side) > INSTALLATION



1. INSTALL REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    B272852E01
  1. Install the rear seat inner with center belt assembly LH with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    1. Install the anchor plate with the arrow mark facing forward.
    2. Do not place the anchor plate over the convex area of the floor panel.

    Text in Illustration 
    *a
    Arrow Mark
    *b
    Convex



2. INSTALL REAR SEAT CUSHION COVER WITH PAD SUB-ASSEMBLY (for Fold Down Seat Type)


    B272781J02
  1. Pass the rear seat inner belt through the slit of the rear seat cushion cover with pad sub-assembly.
    Text in Illustration 
    *1
    Rear Side of Rear Seat Cushion Frame
    *2
    Rear Seat Cushion Lock Hook

  1. Align the rear side of the rear seat cushion frame with the 2 hooks.

  1. Engage the 2 hooks with the rear seat cushion lock hooks to install the rear seat cushion with cover pad sub-assembly.

    NOTICE:
    Check that the rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.



3. INSTALL REAR SEAT CUSHION COVER WITH PAD SUB-ASSEMBLY (for 60/40 Split Seat Type)


    B272781E01
  1. Pass the rear seat inner belt through the slit of the rear seat cushion cover with pad sub-assembly.
    Text in Illustration 
    *1
    Rear Side of Rear Seat Cushion Frame
    *2
    Rear Seat Cushion Lock Hook

  1. Align the rear side of the rear seat cushion frame with the 2 hooks.

  1. Engage the 2 hooks with the rear seat cushion lock hooks to install the rear seat cushion cover with pad sub-assembly.

    NOTICE:
    Check that the rear seat cushion lock hooks and the rear seat cushion frame are securely engaged.