Home › Vehicle Interior › DOOR LOCK › UNLOCK WARNING SWITCH (for Sedan)

UNLOCK WARNING SWITCH (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE STEERING COLUMN COVER


    C139093E01
  1. Remove the 3 screws, disengage the 2 claws, release the tilt lever and remove the steering column lower cover.



    C139094E01
  1. Disengage the claw and remove the steering column upper cover.



3. REMOVE UN-LOCK WARNING SWITCH ASSEMBLY


B118054
  1. Insert the key into the ignition key cylinder.

  1. Disconnect the connector.

  1. Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the unlock warning switch.