WINDOW DEFOGGER WIRE (for Sedan) > ON-VEHICLE INSPECTION |
| 1. INSPECT BACK DOOR GLASS (DEFOGGER WIRE) |
Turn the ignition switch ON.
Turn the defogger switch ON.
![]() |
Check the voltage.
Using a voltmeter, measure the voltage at the center of each defogger wire as shown in the illustration.
| Voltage | Condition |
| Approximately 5 V | Wire not broken |
| Approximately 10 or 0 V | Wire broken |
![]() |
Place the positive (+) voltmeter probe against the defogger wire on the battery side.
Place the foil strip on the negative (-) voltmeter probe against the wire on the ground side.
Slide the positive (+) probe from the battery side to the ground side.
The point where the voltage drops from approximately 10 V to 0 V is where the defogger wire is broken.
| 2. INSPECT REAR WINDOW DEFOGGER |
Check the operation.
Check that the indicator illuminates and the rear window defogger becomes warm when the rear defogger switch is pressed.