Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER WIRE (for Hatchback)

WINDOW DEFOGGER WIRE (for Hatchback) > REPAIR



1. IF NECESSARY, REPAIR DEFOGGER WIRE


    B106758E17
  1. Clean the broken wire tips with grease, wax and silicone remover.
    Text in Illustration 
    *1
    Masking Tape
    *a
    Repair Point
    *b
    Broken Wire

  1. Place masking tape along both sides of the wire.



    B106759
  1. Thoroughly stir the repair agent (DuPont paste No. 4817 or the equivalent).

  1. Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.