Home › Brake › BRAKE (REAR) › REAR BRAKE (for Sedan)

REAR BRAKE (for Sedan) > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR BRAKE SHOE KIT


C108968E01
  1. Using SST, separate the shoe return spring from the front brake shoe.

    SST
    09703-30010  

    NOTICE:
    Do not damage the wheel cylinder boot.



    C108969E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.

    SST
    09718-00010  

  1. Remove the tension spring.



    C108970
  1. Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.



    C108971E01
  1. Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.

    SST
    09718-00010  



    C108972
  1. Using needle-nose pliers, separate the parking brake cable.



2. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER


C062254
  1. Remove the automatic adjust lever tension spring and remove the automatic adjust lever.



3. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY


C108974
  1. Using a union nut wrench, separate the brake tube from the rear wheel brake cylinder.

    HINT:
    Use a container to catch the brake fluid.



    C108975
  1. Remove the bleeder plug cap.

  1. Remove the bleeder plug.

  1. Remove the bolt and remove the rear wheel brake cylinder.



4. REMOVE REAR WHEEL CYLINDER KIT


F044261E01
  1. Remove the 2 wheel cylinder boots from the wheel brake cylinder.

  1. Remove the 2 pistons.

  1. Remove the compression spring.

  1. Remove the wheel cylinder cup from each piston.