REAR BRAKE (for Hatchback Drum Type) > DISASSEMBLY |
| 1. REMOVE REAR BRAKE SHOE KIT |
![]() |
Using SST, separate the shoe return spring from the front brake shoe.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
Remove the tension spring.
![]() |
Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
![]() |
Using needle-nose pliers, separate the parking brake cable.
| 2. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER |
![]() |
Remove the automatic adjust lever tension spring and the automatic adjust lever.
| 3. REMOVE REAR DRUM BRAKE BLEEDER PLUG CAP |
| 4. REMOVE REAR DRUM BRAKE BLEEDER PLUG |
| 5. REMOVE REAR WHEEL BRAKE CYLINDER ASSEMBLY |
![]() |
Using a union nut wrench 10 mm, separate the brake tube from the rear wheel brake cylinder.
Remove the bolt and rear wheel brake cylinder.
| 6. REMOVE REAR WHEEL CYLINDER KIT |
![]() |
Remove the 2 wheel cylinder boots from the wheel brake cylinder.
| *1 | Wheel Cylinder Boot |
| *2 | Wheel Cylinder Piston |
| *3 | Wheel Cylinder Cup |
| *4 | Compression Spring |
Remove the 2 pistons.
Remove the wheel cylinder cup from each piston.
Remove the compression spring.