REAR BRAKE (for Hatchback Drum Type) > REASSEMBLY |
| 1. INSTALL REAR WHEEL CYLINDER KIT |
![]() |
Apply lithium soap base glycol grease to 2 new wheel cylinder cups and the 2 pistons.
| *1 | Lithium Soap Base Glycol Grease |
Install the wheel cylinder cup onto each piston.
Install the compression spring and 2 pistons onto the wheel brake cylinder.
Install 2 new wheel cylinder boots onto the wheel brake cylinder.
| 2. INSTALL REAR WHEEL BRAKE CYLINDER ASSEMBLY |
Install the wheel brake cylinder with the bolt.
Using a union nut wrench 10 mm, install the brake tube.
| 3. TEMPORARILY TIGHTEN REAR DRUM BRAKE BLEEDER PLUG |
| 4. INSTALL REAR DRUM BRAKE BLEEDER PLUG CAP |
| 5. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER |
Install the automatic adjust lever and automatic adjust lever tension spring onto the front brake shoe.
| 6. INSTALL REAR BRAKE SHOE KIT |
![]() |
Apply high temperature grease to the surface of the backing plate which is in contact with the shoe.
| *1 | High Temperature Grease |
![]() |
Using needle-nose pliers, install the parking brake cable onto the parking brake shoe lever.
![]() |
Using SST, install the rear brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
![]() |
Apply high temperature grease to the adjusting bolt.
| *1 | High Temperature Grease |
![]() |
Install the parking brake shoe strut set as shown in the illustration.
| *1 | Backing Plate |
| *2 | Parking Brake Shoe Strut Set |
![]() |
Using SST, install the front brake shoe, pin, shoe hold down spring and shoe hold down spring cup.
![]() |
Using needle-nose pliers, install the tension spring onto the front brake shoe and rear brake shoe.
![]() |
Using SST, install the shoe return spring onto the front brake shoe.
| 7. CHECK REAR DRUM BRAKE INSTALLATION |
Check that each part is installed properly.

| *a | for LH Side | *b | for RH Side |
![]() | Front of the Vehicle | - | - |
![]() |
Measure the brake drum inner diameter and the diameter of the brake shoes. Check that the difference between the diameters is equal to the specified shoe clearance.