FRONT DRIVE SHAFT ASSEMBLY (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN AUTOMATIC TRANSAXLE FLUID (for Automatic Transaxle) |
Remove the drain plug and gasket, and drain the ATF.
Install a new gasket and the drain plug.
| 3. DRAIN MANUAL TRANSAXLE OIL (for Manual Transaxle) |
Remove the filler plug and the gasket.
Remove the drain plug and the gasket, and then drain the manual transaxle oil.
Install a new gasket and the drain plug.
| 4. REMOVE FRONT WHEEL |
| 5. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the axle hub nut.
Using a 30 mm socket wrench, remove the axle hub nut.
| 6. SEPARATE FRONT SPEED SENSOR (w/ ABS) |
![]() |
Remove the bolt and separate the speed sensor and flexible hose.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 7. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link from the shock absorber.
| 8. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Using SST, separate the tie rod end from the steering knuckle.
| 9. SEPARATE FRONT LOWER SUSPENSION ARM |
![]() |
Remove the clip and castle nut.
![]() |
Using SST, separate the lower arm.
| 10. SEPARATE FRONT AXLE ASSEMBLY |
Using a plastic hammer, tap the end of the drive shaft and disengage the fitting between the drive shaft and front axle.
Push the front axle out of the vehicle to remove the drive shaft from the front axle.
| 11. REMOVE AUTOMATIC TRANSMISSION CASE PROTECTOR (w/o ABS) |
![]() |
Remove the 2 bolts and transmission case protector.
| 12. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the drive shaft.
| 13. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
![]() |
Using a screwdriver and hammer, remove the drive shaft.
| 14. FIX FRONT AXLE ASSEMBLY |
![]() |