RADIATOR (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. CHECK WATER FILLER CAP SUB-ASSEMBLY |
![]() |
Measure the valve opening pressure.
If there are water stains or foreign matter on rubber packing 1, 2 or 3, clean the part(s) with water and finger scouring.
Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.
Check that rubber packings 3 and 4 are not stuck together.
Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.
When using the cap tester, tilt it to more than 30 degrees.
![]() |
Pump the cap tester several times, and check the maximum pressure *1.
| Item | Specified Condition |
| Standard value (for brand-new cap) | 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi) |
| Minimum standard value (after using cap) | 78.5 kPa (0.8 kgf/cm2, 11.4 psi) |
| *1 | Radiator Cap Tester |
| *2 | Water Filler Cap Sub-Assembly |
| *a | 30° or more |
| 2. INSPECT FINS FOR BLOCKAGE |
![]() |
If the fins are clogged, wash them with water or a steam cleaner and dry them with compressed air.
| Injection Pressure kPa (kgf/cm2, psi) | Injection Distance mm (in.) |
| 2.942 to 4.903 (30 to 50, 427 to 711) | 300 (11.811) |
| 4.903 to 7.845 (50 to 80, 711 to 1.138) | 500 (19.685) |