Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT (for Sedan)

LIGHT CONTROL RHEOSTAT (for Sedan) > INSTALLATION



1. INSTALL LIGHT CONTROL RHEOSTAT


E116831
  1. Engage the 2 claws and install the light control rheostat.

  1. Connect the connector.



2. INSTALL INSTRUMENT PANEL BOX
  1. Insert the stopper of the instrument panel box from the cutout of the lower instrument panel.



    B176559
  1. Engage the 2 hinges with the instrument panel open.

  1. Close the instrument panel box.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }