REAR AIRBAG SENSOR (for Hatchback 5 Door) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 3. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side) |
| 4. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side) |
| 5. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type) |
| 6. REMOVE DECK BOARD ASSEMBLY |
![]() |
Remove the deck board.
| 7. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side) |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
| *1 | Protective Tape |
Disconnect the connector and remove the No. 2 room light assembly.
| 8. REMOVE JACK HANDLE (for RH Side) |
| 9. REMOVE REAR FLOOR FINISH PLATE |
![]() |
Disengage the 4 claws and 4 guides and remove the rear floor finish plate.
| 10. REMOVE REAR DOOR SCUFF PLATE |
![]() |
Disengage the 4 claws and 4 guides and remove the rear floor finish plate.
| 11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Remove the rear door opening trim weatherstrip.
| 12. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY |
![]() |
Remove the bolt.
Disengage the 2 claws and separate the rear seat 3 point type outer belt.
| 13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) |
![]() |
Remove the 3 screws.
Disengage the 4 claws and the guide.
Disengage the 3 clips and remove the deck trim side panel.
| 14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) |
| 15. REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
![]() |
Disconnect the connector from the No. 2 side airbag sensor assembly.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
![]() |
Remove the bolt and No. 2 side airbag sensor assembly.