Home › Vehicle Interior › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door)

REAR SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door) > REMOVAL


HINT:
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.



1. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
(Click here)


2. REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
(Click here)


3. REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
(Click here)


4. REMOVE DECK BOARD ASSEMBLY


    B272608
  1. Remove the deck board.



5. REMOVE NO. 2 ROOM LIGHT ASSEMBLY


    E222045E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the connector and remove the No. 2 room light assembly.



6. REMOVE JACK HANDLE (for RH Side)


7. REMOVE REAR FLOOR FINISH PLATE


    B272624
  1. Disengage the 4 claws and 4 guides and remove the rear floor finish plate.



8. REMOVE FRONT DOOR SCUFF PLATE


    B284313
  1. Disengage the 8 claws and remove the front door scuff plate.



9. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    B284315
  1. Remove the front door opening trim weatherstrip.



10. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B282669
  1. Disengage the 3 claws to remove the lap belt outer anchor cover.



    B282670
  1. Remove the bolt and disconnect the floor anchor part of the front seat outer belt assembly.



11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


    B284318
  1. Disengage the 8 clips and 10 claws.

  1. Disengage the 3 guides and remove the quarter trim panel.



12. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    B284323
  1. Remove the bolt.

  1. Disengage the 2 claws and separate the rear seat 3 point type outer belt.



13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)


    B284324
  1. Remove the 3 screws.

  1. Disengage the 3 clips and the 3 claws and remove the deck trim side panel.



14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

HINT:
Use the same procedure as for the RH side.



15. REMOVE ROOF SIDE INNER GARNISH


    B284325
  1. Disengage the 5 clips.

  1. Pass the rear seat 3 point type outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.



16. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    B282719
  1. Remove the bolt and the shoulder anchor.



    B282720
  1. Remove the bolt, disengage the 2 hooks to remove the rear seat 3 point type outer belt assembly.



17. REMOVE SEAT BELT HOLE SEAL


    B293016
  1. Disengage the 2 claws to remove the seat belt hole seal.