FRONT AXLE HUB (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEEL |
| 3. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the axle hub nut.
Using a 30 mm socket wrench, remove the axle hub nut.
| 4. SEPARATE FRONT SPEED SENSOR (w/ ABS) |
![]() |
Remove the bolt and separate the speed sensor and flexible hose.
![]() |
Remove the bolt and separate the speed sensor from the steering knuckle.
| 5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the disc brake caliper from the steering knuckle.
| 6. REMOVE FRONT DISC |
![]() |
Place matchmarks on the disc and axle hub and remove the disc.
| 7. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link from the shock absorber.
| 8. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and castle nut.
![]() |
Using SST, separate the tie rod end from the steering knuckle.
| 9. SEPARATE FRONT LOWER SUSPENSION ARM |
![]() |
Remove the clip and castle nut.
![]() |
Using SST, separate the lower arm.
| 10. REMOVE FRONT AXLE ASSEMBLY |
Using a plastic hammer, tap the end of the drive shaft and disengage the fitting between the drive shaft and front axle.
Push the front axle out of the vehicle to remove the drive shaft from the front axle.
![]() |
Remove the 2 nuts and 2 bolts and remove the front axle assembly.
| 11. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the hole snap ring.
| 12. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
![]() |
Fix the steering knuckle in a vise between aluminum plates.
Using SST, remove the axle hub.
![]() |
Using SST, remove the hub bearing inner race from the axle hub.
| 13. REMOVE FRONT DISC BRAKE DUST COVER |
![]() |
Remove the dust cover by tapping the back side with a brass bar and hammer.
| 14. REMOVE FRONT AXLE HUB BEARING |
![]() |
Install the removed hub bearing inner race onto the outer side of the hub bearing.
Using SST and a press, remove the hub bearing from the steering knuckle.