Home › Drivetrain ยท AXLE AND DIFFERENTIAL › REAR AXLE HUB BOLT (for Sedan)

REAR AXLE HUB BOLT (for Sedan) > REPLACEMENT

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    F046068E02
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



3. REMOVE REAR AXLE HUB BOLT


C121818
  1. Using SST and a screwdriver or the equivalent, remove the hub bolt.

    SST
    09611-12010  



4. INSTALL REAR AXLE HUB BOLT


C121819E01
  1. Install the washer and the nut onto a new hub bolt as shown in the illustration.

  1. Using a screwdriver or the equivalent to hold the hub and bearing, install the hub bolt by tightening the nut.



5. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY


6. ADJUST REAR DRUM BRAKE SHOE CLEARANCE
  1. Provisionally install the 2 hub nuts.



    F040023E07
  1. Remove the hole plug, and turn the adjuster to expand the shoe until the drum locks.
    Text in Illustration 
    *1
    Automatic Adjust Lever
    V100135
    Expand

  1. Using a screwdriver, release the adjuster 12 notches.

  1. Install the hole plug.



7. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }