FRONT AXLE HUB (for Sedan) > ON-VEHICLE INSPECTION |
| 1. REMOVE FRONT WHEEL |
| 2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the disc brake caliper from the steering knuckle.
| 3. REMOVE FRONT DISC |
![]() |
Place matchmarks on the disc and axle hub and remove the disc.
| 4. INSPECT FRONT AXLE HUB BEARING |
![]() |
Inspect the axle hub backlash.
Using a dial indicator, check the backlash near the center of the axle hub.
![]() |
Inspect the axle hub runout.
Using a dial indicator, check the runout of the surface of the axle hub.
| 5. INSTALL FRONT DISC |
![]() |
Align the matchmarks of the disc and axle hub and install the disc.
| *a | Matchmark |
| 6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY |
Install the disc brake caliper onto the steering knuckle.
| 7. INSTALL FRONT WHEEL |