Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL SWITCH (for Sedan)

DOOR CONTROL SWITCH (for Sedan) > INSPECTION



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


B141911E01
  1. Check the resistance of the door control switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      1 - 2
      LOCK
      Below 1 Ω
      1 - 2
      OFF
      10 kΩ or higher
      1 - 9
      OFF
      10 kΩ or higher
      1 - 9
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.



2. INSPECT DOOR CONTROL SWITCH


B141929
  1. Check the resistance of the door control switch.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      3 - 4
      LOCK
      Below 1 Ω
      3 - 4
      OFF
      10 kΩ or higher
      2 - 4
      OFF
      10 kΩ or higher
      2 - 4
      UNLOCK
      Below 1 Ω

      If the result is not as specified, replace the door control switch.