TRANSMITTER BATTERY (for Sedan) > REPLACEMENT |
| 1. REMOVE TRANSMITTER BATTERY |
![]() |
Remove the transmitter battery.
Using a screwdriver with its tip wrapped in protective tape, pry apart the transmitter housing cover.
![]() |
Remove the door control transmitter module from the transmitter housing case.
![]() |
Disengage the hook and remove the transmitter battery cover.
![]() |
Remove the battery (lithium battery: CR2016).
| 2. INSTALL TRANSMITTER BATTERY |
![]() |
Install the transmitter battery.
Install a battery (lithium battery: CR2016) with the positive (+) side up, as shown in the illustration.
![]() |
Install the cover securely.
![]() |
Install the door control transmitter module into the transmitter housing case.
![]() |
Install the transmitter housing cover onto the transmitter housing case securely.
After installation, press any of the transmitter switches. Check that the LED illuminates.