EXHAUST PIPE (for Sedan) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL |
![]() |
Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
| 2. REMOVE INSTRUMENT PANEL FINISH PANEL END LH |
![]() |
Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.
| 3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Remove the shift lever knob.
| 4. REMOVE CONSOLE BOX UPPER PANEL SUB-ASSEMBLY |
![]() |
Shift the shift lever into the N position.
Disengage the 5 clips and the claw and remove the upper console panel.
| 5. REMOVE CONSOLE BOX UPPER REAR PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 clips and 3 claws.
Disconnect the connector and remove the console upper rear panel.
| 6. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
| 7. REMOVE CONSOLE BOX ASSEMBLY |
![]() |
Disconnect the clamp.
Remove the 2 bolts and 2 screws.
Disengage the 4 claws and remove the rear console box.
| 8. REMOVE LOWER INSTRUMENT PAD LH |
![]() |
Remove the <H> screw.
Disengage the claw and 3 clips and remove the instrument pad lower.
| 9. REMOVE HEATED OXYGEN SENSOR |
Disconnect the sensor connector.
Remove the grommet and pass the sensor connector out of the cabin through the floor panel.
![]() |
Using SST, remove heated oxygen sensor.
| 10. REMOVE EXHAUST TAIL PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Remove the 3 No. 4 exhaust pipe supports and the exhaust tail pipe assembly.

| 11. REMOVE FRONT EXHAUST PIPE ASSEMBLY |
Remove the 2 bolts and 2 compression springs.
Remove 3 No. 4 exhaust pipe support and the front exhaust pipe assembly.

Remove the 2 exhaust pipe gaskets.