ANTI-LOCK BRAKE SYSTEM (for Sedan) > TERMINALS OF ECU |
| TERMINALS OF ECU |
![]() |
| *a | Component without harness connected (Skid Control ECU) |
| Terminal No. (Symbol) | Terminal Description |
| A15-1 (GND1) | Skid control ECU ground |
| A15-4 (RL-) | Rear wheel speed LH (-) signal input |
| A15-5 (RL+) | Rear wheel speed LH (+) power supply output |
| A15-6 (FR-) | Front wheel speed RH (-) signal input |
| A15-7 (FR+) | Front wheel speed RH (+) power supply output |
| A15-12 (+BS) | Solenoid relay power supply |
| A15-13 (GND2) | Pump motor ground |
| A15-14 (CANL) | CAN communication line L |
| A15-16 (RR-) | Rear wheel speed RH (-) signal input |
| A15-17 (RR+) | Rear wheel speed RH (+) power supply output |
| A15-18 (FL-) | Front wheel speed LH (-) signal input |
| A15-19 (FL+) | Front wheel speed LH (+) power supply output |
| A15-24 (+BM) | Motor relay power supply |
| A15-25 (CANH) | CAN communication line H |
| A15-28 (STP) | Stop light switch input |
| A15-34 (IG1) | ECU power supply |
| TERMINAL INSPECTION |
![]() |
Disconnect the connector and measure the voltage or resistance on the wire harness side.
| *a | Front view of wire harness connector (to Skid Control ECU) |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| A15-1 (GND1) - Body ground | W-B | Skid control ECU ground | Always | Below 1 Ω |
| A15-12 (+BS) - Body ground | W | Solenoid relay power supply | Always | 11 to 14 V |
| A15-13 (GND2) - Body ground | W-B | Pump motor ground | Always | Below 1 Ω |
| A15-28 (STP) - Body ground | G | Stop light switch input | Stop light switch ON → OFF (Brake pedal depressed → released) | 8 to 14 V → Below 1.5 V |
| A15-24 (+BM) - Body ground | B | Motor relay power supply | Always | 11 to 14 V |
| A15-25 (CANH) - A15-14 (CANL) | G-W | CAN BUS | Ignition switch off | 54 to 69 Ω |
| A15-34 (IG1) - Body ground | B | ECU power supply | Ignition switch ON | 11 to 14 V |