VEHICLE STABILITY CONTROL SYSTEM (for Hatchback) > TERMINALS OF ECU |
| TERMINALS OF ECU |
![]() |
| *a | Component without harness connected (Skid Control ECU (Brake Actuator Assembly)) |
| Terminal No. (Symbol) | Terminal Description |
| A70-1 (GND1) | Skid control ECU ground |
| A70-2 (STP) | Stop light switch input |
| A70-4 (RL-) | Rear wheel speed LH (-) signal input |
| A70-5 (RL+) | Rear wheel speed LH (+) power supply output |
| A70-6 (FR-) | Front wheel speed RH (-) signal input |
| A70-7 (FR+) | Front wheel speed RH (+) power supply output |
| A70-11 (SP1) | Speed signal output for speedometer |
| A70-12 (+BS) | Solenoid relay power supply |
| A70-13 (GND2) | Pump motor ground |
| A70-14 (CANL) | CAN communication line L |
| A70-16 (RR-) | Rear wheel speed RH (-) signal input |
| A70-17 (RR+) | Rear wheel speed RH (+) power supply output |
| A70-18 (FL-) | Front wheel speed LH (-) signal input |
| A70-19 (FL+) | Front wheel speed LH (+) power supply output |
| A70-24 (BM) | Motor relay power supply |
| A70-25 (CANH) | CAN communication line H |
| A70-30 (CSW) | VSC OFF switch input |
| A70-34 (IG1) | ECU power supply |
| TERMINAL INSPECTION |
![]() |
Disconnect the connector and measure the voltage or resistance on the wire harness side.
| *a | Front view of wire harness connector (to Skid Control ECU (Brake Actuator Assembly)) |
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| A70-1 (GND1) - Body ground | W-B - Body ground | Skid control ECU ground | Always | Below 1 Ω |
| A70-2 (STP) - Body ground | P - Body ground | Stop light switch input | Stop light switch on → off (Brake pedal depressed → released) | 7.5 to 14 V → Below 1.5 V |
| A70-12 (+BS) - Body ground | W - Body ground | Solenoid relay power supply | Always | 11 to 14 V |
| A70-13 (GND2) - Body ground | W-B - Body ground | Pump motor ground | Always | Below 1 Ω |
| A70-24 (BM) - Body ground | B - Body ground | Motor relay power supply | Always | 11 to 14 V |
| A70-25 (CANH) - A70-14 (CANL) | G - W | CAN bus | Ignition switch off | 54 to 69 Ω |
| A70-30 (CSW) - Body ground | B - Body ground | VSC OFF switch input | VSC OFF switch held on → off (Not pressed) | Below 25 Ω → 10 kΩ or higher |
| A70-34 (IG1) - Body ground | L - Body ground | ECU power supply | Ignition switch ON | 11 to 14 V |