Home › Vehicle Exterior › LIGHTING (EXT) › RELAY (for Sedan)

RELAY (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT HEADLIGHT RELAY


E109076E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the headlight relay.



2. INSPECT FOG LIGHT RELAY


E109078E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard Resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω
      (Battery voltage applied to terminals 1 and 2)

      If the result is not as specified, replace the fog light relay.