Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH (for Sedan)

WASHER LEVEL WARNING SWITCH (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT WASHER LEVEL WARNING SWITCH


E129626
  1. Check the operation of the washer level warning switch.

    1. Fill the washer jar with washer fluid.

      HINT:
      The operation should be performed with the washer level warning switch installed on the washer jar.

    2. Connect the positive (+) battery lead to terminal 1 of the washer level warning switch, and the negative (-) battery lead to terminal 2.

    3. Check the resistance.

      HINT:
      Pull out the washer hose connected to the washer motor. Perform the inspection while draining the washer fluid off.

      Standard Resistance 
      Amount of remaining washer fluid
      Specified Condition
      600 to 800 ml or more
      10 kΩ or higher
      600 to 800 ml or less
      Below 1Ω
      If the result is not as specified, replace the washer jar .